Stucco Verification Checklist PDF

Full QC Checklist+

Verify measurement, substrate/system selection, lath/accessories, and installation before handover.

✓20 Inspection Points

✓4 Verification Categories

✓Measurement & Takeoff+

Every wall section's width and height were measured on site, not estimated from a floor plan alone.
Window and door counts and typical sizes were recorded for each wall section that has openings, not assumed uniform across the whole house.
Outside corner count matches the building's actual footprint, including any bump-outs, bay windows, or wing additions.
Overall wall height (corner bead sizing only) reflects the tallest point a corner run must cover, e.g. full two-story height where applicable.
Gable end walls were added as their own row with a reasonable average height, or their triangular area was measured separately.

✓Substrate & System Selection+

Substrate type (Frame + Lath vs. Direct-to-Masonry) matches the actual wall construction — this changes whether lath, paper, fasteners, and weep screed are needed at all.
Framing spacing (if Frame + Lath) matches the actual stud/joist layout, not just this calculator's default.
Finish coat type (cementitious or acrylic) and, if acrylic, the texture grade, match the actual product ordered — texture alone can roughly double or triple pail count for the same area.
Waste allowance (5-15%) matches the job's actual complexity — more openings and cuts need a higher allowance.
Outside temperature and weather forecast were checked against the product's minimum/maximum application temperature range before scheduling each coat.

✓Lath, Paper & Accessories+

Lath is self-furring (or furred) and meets a minimum weight/gauge standard appropriate for the span — confirmed against the local code and product spec, not assumed from this calculator's sheet count alone.
2 layers of Grade D (or equivalent) building paper are planned behind the lath over wood-based sheathing, correctly lapped at seams.
A weep screed is planned at the base of every frame+lath wall for drainage — never omitted, and never substituted on a masonry/concrete wall where it isn't needed.
Corner bead is planned at every outside corner for a straight, impact-resistant edge; casing bead is planned around every window and door opening.
Control joint locations were confirmed against an engineered layout or local best practice, not relied on from this calculator's planning-level estimate alone.

✓Installation & Final Check+

Scratch coat is applied with enough pressure to fully encase the lath and is scored/raked before it sets, per standard plastering practice.
Adequate cure/cure-water time was scheduled between scratch, brown, and finish coats — stucco is a multi-day process, not a single-visit install.
Bag, lath, paper, accessory, and fastener quantities including the waste allowance — not the raw calculated totals — were used for the material order.
Weather forecast was checked before each coat — stucco should not be applied in freezing temperatures or immediately before heavy rain.
Final finish coat texture and color were sampled and approved before coating the full wall area.

Inspection Notes+

Use the latest approved drawings, specifications, and site measurements.

Complete all critical checks before proceeding to the next work stage.

Record deviations and confirm rectification where required.

Inspection Notes

Use the latest approved drawings, specifications, and site measurements.

Complete all critical checks before proceeding to the next work stage.

Record deviations and confirm rectification where required.

Use it after collecting the project inputs and again before approving or closing the relevant work stage.

No. It supports verification but does not replace approved drawings, specifications, codes, manufacturer requirements, or professional inspection.